- Years of Manufacture: 1967 - 1972
- Number Built: 198,085
- Price at Introduction (UK):
- 1600 Basic: £665
- 1600 Tax: £154
- 2000 Basic: £739
- 2000 Tax: £171
- 4 Speed Gearbox: £14 15s
- Auto Gearbox (2000): £83 11s
- Overdrive (4 Spd Only): £42
- Power Assisted Discs (1600): £15 7s
- Bucket Seats (1600): £22 2s
- 2000 engine with disc brakes and low-profile tires: £24 11s
- Alternator (1600): £3 13s
- Heated backlight (only available on cars fitted with alternator): £12 18s
- 6.9 x 13 Low Profile tires
- 1600: £5 16s
- 2000: £3 13s
- 165 13in. Radial Ply tires
- Body:
- Exterior Dimensions:
- Total Length: 14ft. 8.7in. (449cm)
- Total Width:
5ft. 6.9in. (170cm)
- Total Height at kerb weight:
- 1600: 4ft. 4.4in. (133cm)
- 2000: 4ft. 3.7in. (131cm)
- Wheelbase: 8ft. 6in. (305cm)
- Front Track:
- 1600: 4ft. 6in. (137cm)
- 2000: 4ft. 6.6in. (138cm)
- Rear Track:
- 1600: 4ft. 6in. (137cm)
- 2000: 4ft. 6in. (137cm)
- Kerb Weight:
- 1600: 2,321lb. (1053kg)
- 2000: 2,350lb. (1066cm)
- Turning Circle:
- Fuel Tank Capacity:
- Equipment:
- Battery: 12 volt, 38 amp hour
- Dynamo on 1600, alternator on 2000
- Four headlamp system, 175/75 watt total
- Reversing lamps: Optional extra
- Electrical fuses: 4 + circuit breaker for headlamps
- Screen wipers: Single speed, self parking
- Screen washer: Standard, electric
- Interior heater: Standard, fresh air type
- Safety belts: Optional extra, however anchorages built-in
- Interior Trim: PVC seats, trim and headlining
- Floor coverings: Carpets, moulded cut pile tufted
- Jack: Screw scissors
- Jacking points: 4, 2 each side
- Windscreen: Triplex zone toughened
- Underbody protection: Phosphate coat and aluminized bitumen
|
- 1600 4 cylinder in-line engine, inclined at 45°:
- Capacity: 1599cc 97.5 cu. in.
- Type: Conventional, watercooled four
stroke, reciprocating piston type with
4 cylinders
- Configuration: Front mounted, longitudinal,
inline, single overhead camshaft
- Head: Pushrod and rocker actuated ohv
with two valves per cylinder
- Fuel System: AC Mechanical, Zenith 36 IV carburetor
- Bore and Stroke: 3.375 x 2.276 inches
(85.73 x 69.24mm)
- Power: 83bhp at 5800rpm
- Torque: 90lb-ft at 3200rpm
- Compression Ratio: 8.5:1
- 2000 4 cylinder in-line engine, inclined at 45°:
- Capacity: 1975cc 120.5 cu. in.
- Type: Conventional, watercooled four
stroke, reciprocating piston type with
4 cylinders
- Configuration: Front mounted, longitudinal,
inline, single overhead camshaft
- Head: Pushrod and rocker actuated ohv
with two valves per cylinder
- Fuel System: AC Mechanical, Zenith 36 IV carburetor
- Bore and Stroke: 3.750 x 2.276 inches
(95.25 x 69.24mm)
- Power: 104bhp at 5800rpm
- Torque: 118lb-ft at 3200rpm
- Compression Ratio: 8.5:1
- Ignition and Electrical:
- Cooling System:
- Water, pump, fan and thermostat
- 13.5 pints capacity, including heater of 7.7 liters
- Engine Sump:
- Dry: 805 pints (4.8 liters), refill 7.5 pints (4.3 liters) SAE 20 or 20W
- Manufacturer recommended oil change every 6000 miles
- Change filter element every 6000 miles
- Manual Transmission 1600 (3 speed - all synchromesh):
- 1st: 3.19:1
- 2nd: 1.64:1
- 3rd: 1.00:1
- Reverse: 3.05:1
- Manual Transmission 1600 (4 speed - all synchromesh):
- 1st: 3.29:1
- 2nd: 2.13:1
- 3rd: 1.36:1
- 4th: 1.00:1
- Reverse: 3.05:1
- Manual Transmission 2000 (3 speed - all synchromesh):
- 1st: 2.87:1
- 2nd: 1.64:1
- 3rd: 1.00:1
- Reverse: 3.05:1
- Manual Transmission 2000 (4 speed - all synchromesh):
- 1st: 2.77:1
- 2nd: 1.94:1
- 3rd: 1.36:1
- 4th: 1.00:1
- Reverse: 3.05:1
- Automatic Transmission (3 speed, available on 2000 only):
- 1st: 2.39-4.81
- 2nd: 1.45-3.04
- 3rd: 1-2:1
- Reverse: 2.09-4.39
- Clutch:
- Diaphragm single dry plate
- 1600: 7.5 in.
- 2000: 8.0 in
- Rear Axle Ratio:
- 1600: 4.125:1
- 2000: 3.9:1
- Suspension:
- Front: Independent, wishbones, coil springs, parallel trailing arms, Panhard rod telescopic dampers
- Rear: Live axle, coil springs, parallel trailing arms, Panhard rod telescopic dampers
- Steering:
- Rack and pinion, wheel diameter 15.4 inches
- Turns lock-to-lock: 4.4
- Brakes:
- 1600: Drums front and rear, front disc optional
- 2000: Front disc, rear drum
- Standard vacuum type servo
- Dimensions:
- 1600 Front: 9.0 in. dia. with 1.75 in. wide shoes
- 1600 Rear: 9.0 in. dia. with 1.75 in. wide shoes
- 2000 Front: 10.06 in. dia. disc
- 2000 Rear: 9.0 in. dia. with 1.75 in. wide shoes
- Swept Area:
- 1600 Front: 98.8 sq. in.
- 1600 Rear: 98.8 sq. in.
- 2000 Front: 188 sq. in.
- 2000 Rear: 98.8 sq. in.
- Wheels:
- Pressed steel disc, 4.5 inch wide rim
- Tyres:
- Goodyear, Avon or Firestone, low profile cross-ply tubeless
- 1600: 5.60 x 13
- 2000: 6.2 x 13
|